Faber Repair Service in Mansfield Woodhouse

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

What does a flashing LED light mean on a Faber cooker hood?

A flashing LED light on a Faber cooker hood signals that the activated charcoal filter needs replacing. This alarm appears after approximately 200 hours of operation in recirculation mode. Replace the charcoal filter with a genuine Faber replacement and clean the grease filters, then reset the alarm according to your model's instructions.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why does my Faber cooker hood turn on briefly every hour?

If your Faber cooker hood activates for approximately 10 minutes every hour, the 24-hour air circulation mode is enabled. This eco-friendly feature maintains fresh air in your kitchen by periodically ventilating at low speed throughout the day. To deactivate this mode, press and hold the designated button for approximately 2 seconds with the motor and lights off. Consult your instruction manual for model-specific controls.

How do I clean the metal grease filters on my Faber cooker hood?

Wash the metal grease filters by hand using warm water with neutral or acid-free soap, or place them in the dishwasher. After washing, allow the filters to dry completely before reinstalling.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

What is the difference between ducted and recirculating Faber cooker hoods?

Ducted hoods expel cooking fumes directly outside through external venting, offering superior odour removal and quieter operation. Recirculating hoods filter the air through charcoal filters and return it to the kitchen, offering flexibility as they can be installed anywhere without external ducting.