Faber Repair Service in Ladybrook and Bull Farm

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

Where should the ducting from my Faber cooker hood terminate?

Ducting must terminate outside of your home. A crawl space, attic, basement, or garage does not meet the definition of outside and should not be used as a termination point for the ducting.

Where can I find the user manual for my Faber cooker hood?

User manuals for Faber cooker hoods are available on the individual product pages on the Faber UK website. Locate your hood model and download the manual in PDF format from the product page.

How long should I leave my Faber cooker hood running after cooking?

Leave the hood running on a low speed for approximately 10 minutes after you finish cooking. This ensures all residual odours and steam are removed from the kitchen.