Faber Repair Service in Forest Town

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why are all LEDs flashing three times on my Faber cooker hood?

When all LEDs flash three times simultaneously on a Faber cooker hood, it confirms that the filter saturation alarm has been successfully reset. This is a confirmation signal, not an error, and no action is required.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

Why does my Faber cooker hood run at high speed for only 6 minutes?

When your Faber cooker hood runs at maximum speed and automatically reduces after 6 minutes, this indicates the intensive speed mode is functioning correctly. This timed feature provides maximum extraction power for heavy cooking tasks such as frying or grilling, then automatically returns to a lower speed to conserve energy. This is normal operation, not a fault.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why is my Faber cooker hood remote control not working?

First check whether the batteries need replacing and install fresh CR2032 batteries if necessary. If this does not solve the problem, the remote control receiver on the hood may be deactivated and needs to be reactivated through the hood's control panel.

What is the Faber Long Lasting charcoal filter and how do I maintain it?

The Long Lasting filter is a reusable active carbon filter with multi-layer technology that can be washed in the dishwasher every 3-4 months and lasts for up to 3 years of normal use. After washing, dry it at room temperature in a vertical position or in an oven at 50°C.

How do I clean the metal grease filters on my Faber cooker hood?

Wash the metal grease filters by hand using warm water with neutral or acid-free soap, or place them in the dishwasher. After washing, allow the filters to dry completely before reinstalling.

What types of charcoal filters are available for Faber cooker hoods?

Faber offers several types of charcoal filters for recirculating hoods: standard activated carbon filters (replace every 3-4 months), high-performance activated carbon filters (replace every 6 months), and Long Lasting filters (wash in the dishwasher every 3-4 months, lasting up to 3 years). Check your model's specifications for compatible filter types.

How do I clean the exterior of my Faber cooker hood?

Clean the hood exterior with a damp sponge or cloth and a small amount of mild soap. Rinse thoroughly and dry with a soft cloth. For stainless steel models, finish with a stainless steel polish.