Faber Repair Service in Mansfield Central

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

What does it mean when the LED flashes twice on a Faber cooker hood?

Two LED flashes on a Faber cooker hood can indicate either that the remote control receiver has been activated, or that the activated charcoal filter alarm has been enabled. This is a confirmation signal showing the hood has registered your command.

How often should I replace the charcoal filter on my Faber cooker hood?

Standard charcoal filters should be replaced approximately every 6 months. Faber's Long Lasting charcoal filters can be washed in the dishwasher every 3-4 months and reused for up to 3 years.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.

When should I turn on my Faber cooker hood?

Turn on your cooker hood at least one minute before you start cooking. This allows proper air circulation to be established before cooking vapours and odours are produced.

How do I find the model and serial number of my Faber cooker hood?

The model and serial number of your Faber cooker hood are printed on the label located inside the hood. To access this label, switch off the hood at the mains, then remove the grease filters to reveal the white identification label underneath.

How often should I clean the metal grease filters on my Faber cooker hood?

Metal grease filters should be washed every 2 months under normal cooking conditions (up to 3 hours of use per day). This equates to approximately every 100 hours of hood operation.