Beko Repair Service in Mansfield Woodhouse

What does error code E02 mean on a Beko dishwasher?

Error code E02 on a Beko dishwasher indicates a water flow problem, which may relate to drainage or water inlet depending on your model. Switch off the dishwasher and unplug it from the mains. Clean the filters at the bottom of the dishwasher. Check the drain hose for kinks or blockages. Also verify the water supply tap is fully open and the inlet hose is not kinked. If the error continues, contact a qualified technician.

What does error code E5 mean on a Beko washing machine?

Error code E5 on a Beko washing machine indicates a drainage problem. Switch off the machine and unplug it from the mains. Clean the pump filter located at the bottom front of the machine. Check the drain hose is not kinked or blocked. Ensure the drain hose is positioned correctly. If the problem persists, contact a qualified technician.

What does error code E3 mean on a Beko washing machine?

Error code E3 on a Beko washing machine means the heater is not switching off, indicating a control board relay fault. Switch off the machine immediately and unplug it from the mains. Do not use the machine again until it has been professionally repaired. Contact a qualified technician as this fault requires professional repair.

What does error code E1 mean on a Beko washing machine?

Error code E1 on a Beko washing machine indicates a thermistor (NTC temperature sensor) fault. Switch off the machine and unplug it from the mains. Wait a few minutes, then restart. If the error persists, contact a qualified technician as this fault requires professional diagnosis.

What does error code E11 mean on a Beko washing machine?

Error code E11 on a Beko washing machine indicates a motor error. Switch off the machine and unplug it from the mains. Do not attempt to use the machine until it has been inspected. Contact a qualified technician as motor faults require professional diagnosis and repair.

Why does my new Beko oven smell when I first use it?

A smell from a new oven is normal and caused by protective coatings burning off during initial heating. Before first use, remove all packaging and accessories, then heat the empty oven at maximum temperature for 30-60 minutes with good ventilation. The smell will diminish after a few uses.

Can I reverse the door on my Beko fridge freezer?

Yes, most Beko fridge freezer doors can be reversed. Unplug the appliance, remove all food, and empty the water tank if fitted. The process involves removing doors, repositioning hinges to the opposite side, and rotating hinges 180 degrees. Have someone assist you as the doors are heavy. After completion, wait at least 4 hours before switching on.

How often should I replace the charcoal filter on my Beko cooker hood?

Non-washable charcoal filters should be replaced at least every four months. Washable activated charcoal filters can be cleaned every two months in hot water or dishwasher at 65°C, then dried in an oven at 100°C for 10 minutes. Replace washable filters every three years or if the mattress becomes damaged.

Why is my Beko washing machine not spinning properly?

The most common cause is an unevenly distributed load. When you mix heavy garments like towels with lighter items, the machine cannot achieve full spin speed. Stop the cycle, redistribute clothes evenly, and restart.

How do I clean the spray arms on my Beko dishwasher?

Remove the upper and lower spray arms, then clean them under running water. Ensure the holes are not clogged. Use only soft tools to clear blockages; avoid sharp objects like knives which could damage the spray arms.