Immergas Repair Service in Forest Town

What does the 221 error mean on an Immergas heat pump?

The 221 error on an Immergas heat pump indicates an outdoor unit temperature sensor malfunction. The temperature sensor on the outdoor unit is reporting incorrect readings or has failed. Switch off the heat pump at the isolator switch for five minutes. Switch back on and monitor for the error. If the error persists, contact a qualified technician for sensor testing and replacement.

What does the 202 error mean on an Immergas heat pump?

The 202 error on an Immergas heat pump indicates a sustained communication error between the control kit and outdoor unit lasting more than three minutes. Switch off the heat pump at the isolator switch for five minutes. Switch back on and monitor for the error. If communication is not restored, contact a qualified technician. Do not repeatedly reset the unit as this will not resolve a wiring or component fault.

What does the 20 error mean on an Immergas boiler?

The 20 error on an Immergas boiler indicates a parasite flame block. The flame detection system is sensing a flame signal when the boiler should not be firing, which could indicate a leak in the detection circuit or a flame control unit anomaly. If you smell gas, do not operate any switches, ventilate the area if safe to do so, leave the property immediately, and call the gas emergency service from outside. If there is no gas smell, switch off the boiler at the electrical supply and do not attempt to restart. Contact a Gas Safe registered engineer immediately for inspection.

What does the 462 error mean on an Immergas heat pump?

The 462 error on an Immergas heat pump indicates an absorption error or PFC overcurrent fault from the inverter. The power factor correction circuit is detecting excessive current draw. Switch off the heat pump at the isolator switch immediately. Do not attempt to reset. Contact a qualified technician for electrical system diagnosis. This fault may indicate serious electrical problems requiring professional repair.

What does the 02 error mean on an Immergas boiler?

The 02 error on an Immergas boiler indicates the safety thermostat has activated due to overheating. The boiler has detected excessive internal temperature exceeding 100 degrees Celsius. Switch off the boiler at the electrical supply. Allow the boiler to cool down completely for a minimum of 60 minutes before attempting any reset. Check that all radiator valves are open to ensure adequate water circulation. If the error returns after cooling and reset, contact a qualified technician immediately as repeated overheating can indicate serious internal faults.

What annual maintenance does my Immergas boiler require?

Annual maintenance should include cleaning the heat exchanger on the fume side, cleaning the main burner, verifying correct ignition and operation, and checking burner settings for both heating and hot water phases. A visual inspection for leaks and corrosion is also required.

How do I reset my Immergas boiler?

Locate the reset button on your boiler's control panel, typically marked with a flame symbol or the word Reset. Press the button firmly. On most Immergas models, holding the button for approximately 5 seconds will initiate a restart. If the error clears, the boiler should resume normal operation. If the boiler does not reset or the same error returns, do not repeatedly press the reset button. Contact a qualified technician for diagnosis.

Does my Immergas heat pump have antifreeze protection?

Yes, Immergas heat pumps include automatic antifreeze protection that activates when outdoor temperatures drop below freezing. This prevents damage to the system and water circuits.

How do I repressurise my Immergas boiler?

Locate the filling loop beneath or near your boiler. Open both valves slowly to allow cold mains water into the system while watching the pressure gauge. When it reaches between 1.0 and 1.2 bar, close both valves securely.

What periodic maintenance does my Immergas heat pump need?

Periodic maintenance includes visually checking for water leaks or oxidation on connections, verifying that safety devices have not been tampered with, and ensuring the outdoor unit remains free of debris. Check that drainage for condensate and defrost water is clear.