AEG Repair Service in Forest Town

What does error code i30 mean on an AEG dishwasher?

Error code i30 on an AEG dishwasher indicates water has been detected in the base of the appliance. Do not stand in any pooled water near the appliance. If safe to do so, switch off at the mains and turn off the water supply - only unplug if you can do so without risk of water contact. Leave overnight to allow any foam to disperse. Check for visible leaks around the door seal. If the problem persists, contact a qualified technician.

What does error code E6 or E641 mean on an AEG hob?

Error codes E6 or E641 on an AEG hob indicate insufficient power - the hob is connected to only one phase. This often occurs with incorrect installation. Have a qualified electrician check the connection meets the requirements in the installation instructions.

What does error code E70 mean on an AEG tumble dryer?

Error code E70 on an AEG tumble dryer indicates a temperature sensor fault. WARNING: This is a safety-critical issue. Do not use or attempt to restart the dryer until the problem has been professionally diagnosed. Unplug the appliance immediately and contact a qualified technician.

What does error code E90, E91, E92, E93 or E94 mean on an AEG washing machine?

Error codes E90 to E94 on an AEG washing machine indicate a configuration or electronics communication error. Switch off at the mains for 30 seconds then switch back on. If the error persists, contact a qualified technician as the electronic control board may require professional diagnosis.

What does error code F1 mean on an AEG oven?

Error code F1 on an AEG oven indicates a door closure problem, often related to the pyrolytic function. Check the door is intact, properly secured and fully closed. If the door was recently removed for cleaning, ensure it has been refitted correctly. If the problem persists, contact a qualified technician.

How do I adjust the humidity in my AEG fridge's crisper drawers?

Most AEG fridges have humidity control sliders on the crisper drawers. For leafy vegetables and herbs, use the high humidity setting to retain moisture. For fruits and vegetables that produce ethylene gas, use the low humidity setting to allow air circulation and prevent premature ripening.

How often should I empty the water tank on my AEG tumble dryer?

Empty the water tank after each use. The tumble dryer will automatically stop if the tank becomes full during a cycle.

How can I remove bad odours from my AEG fridge?

Use special odour absorbers designed for fridge use. These help neutralise unpleasant smells that can develop from stored food.

Where can I find the model and serial number on my AEG appliance?

The rating plate with model (PNC) and serial number is typically located: on washing machines and dryers, inside the door frame; on dishwashers, inside the door edge; on fridges and freezers, inside on the left wall; on ovens, behind the door on the frame; on hobs, on the underside. You will need these numbers when ordering spare parts or booking repairs.

Can I wash and dry in one continuous cycle on my AEG washer dryer?

Yes, most AEG washer dryers offer a Non-Stop programme that automatically transitions from washing to drying. However, for best results with full loads, it's recommended to wash first, remove some items to match the drying capacity, then run the drying cycle separately.